RAU6 Dokuwiki

User Tools

Site Tools

Trace: • IoT Networks: Laboratory 3 - CoAP • Bluetooth Low Energy for STM32 - peripheral write • ESP32 BLE in Arduino. Part2: Setting-up BLE Server • ESP32 BLE in Arduino. Part1: Setting-up BLE Beacon • Laboratory on the Internet of Things - Advanced IoT Hardware - on-site edition • ESP32 BLE in Arduino. Part 4: BLE Client • Zephyr Beacon example • Laboratory on GPIO use in Zephyr OS • nRF52840 Zephyr BLE client • Zephyr BLE peripheral
No ACL setup yet! Denying access to everyone.
en:edu:zmitac:s2:aih:lab:nrf52gpiote

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
en:edu:zmitac:s2:aih:lab:nrf52gpiote [2023/11/23 00:33] – ktokarzen:edu:zmitac:s2:aih:lab:nrf52gpiote [2023/12/01 13:51] (current) – ktokarz
Line 4: Line 4:
 ===== Using PPI with GPIO ===== ===== Using PPI with GPIO =====
  
-This part of the laboratory shows how to use the PPI to send the activation information from the button (sw0) directly to the LED (led0). It is possible to set up the hardware connection between the button EVENT signal and the TASK signal for LED. While the output is controlled by the GPIOTE (GPIO Tasks and Events) mechanism the normal GPIO writes have no effect. The GPIOTE mechanism is not supported in Zephyr OS, but the driver (NRFX) which is provided directly by Nordic Semiconductor can be used in Zephyr-compatible software.+This part of the laboratory shows how to use the PPI to send the activation information from the button (sw0) directly to the LED (led0). It is possible to set up the hardware connection between the button EVENT signal and the TASK signal for LED. While the output is controlled by the GPIOTE (GPIO Tasks and Events) mechanism the normal GPIO writes have no effect. The GPIOTE mechanism is not supported in Zephyr OS, but the driver (NRFX) which is provided directly by Nordic Semiconductor can be used in Zephyr-compatible software. Every connection between EVENT and TASK is done by defining the channel. The number of available channels is limited to 8.
 The example provided uses the GPIOTE to handle signalling. To make it work properly the config file must be changed, enabling the NRFX driver, and disabling the general GPIO driver: The example provided uses the GPIOTE to handle signalling. To make it work properly the config file must be changed, enabling the NRFX driver, and disabling the general GPIO driver:
 <code> <code>
Line 21: Line 21:
 CONFIG_LOG=y CONFIG_LOG=y
 </code> </code>
 +
 +===== Tasks to be done during the laboratory =====
 +
 To do this part of the laboratory take the following steps: To do this part of the laboratory take the following steps:
   - Modify the prj.conf file.    - Modify the prj.conf file. 
en/edu/zmitac/s2/aih/lab/nrf52gpiote.1700696013.txt.gz · Last modified: by ktokarz